Filter
Top Products
— 33 —
KV-27S40 / 27S45 / 27S65 / 29SL40 / 29SL40A / 29SL40C/
29SL45 / 29SL65 / 29SL65C/ 29XL40M / 29XL40P / 29XT11A
H. CENTER ADJUSTMENT (HPOS)
Note : Perform this adjustment after checking H. FREQUENCY.
1. Input a cross-hatch signal.
2. Set the Service adjustment Mode.
3. Select HPOS with and .
4. Adjust with
and for the best horizontal center.
5. Write into the memory by pressing
then
V. LINEARITY (VLIN) AND V CORRECTION
1. Input a cross-hatch signal.
2. V. Correction is automatically adjusted from the circuit and
should satisfy the conditions below:
…
SERVICE ADJUSTMENT MODE MEMORY
1. Change DCOL to "1".
2. After completing all adjustments, press "0" then .
/
/
V. SIZE (VSIZ)
DISPLAY POSITION ADJUSTMENT (DISP)
1. Input a color-bar signal.
2. Set to Service adjustment Mode.
3. Select DISP with
and .
4. Adjust with and for adjustment of characters to center .
5. Write the memory by pressing
then .
6. Check if the text is displayed on the screen.
SUB BRIGHT ADJUSTMENT (SBRT)
1. Input a cross-hatch signal.
2. Set to Service adjustment Mode.
3. Set the PICTURE and BRIGHT to minimum.
4. Select SBRT with
and .
5. Adjust with
and to obtain a faintly visible cross-hatch.
6. Write into the memory by pressing then .
SUB HUE, SUB COLOR ADJUSTMENT (SHUE, SCOL)
1. Input a color-bar signal.
2. Set to Service adjustment Mode.
3. Select the item DCOL and set to "0" level.
4. Connect oscilloscope probe to C Board,
CN301 Pin 7
(BLUE OUT).
5. Select SHUE and SCOL with and .
6. Adjust with and for the V1 = V4 ± 0.1Vp-p (SCOL)
and V2 = V3 ± 0.1Vp-p (SHUE).
V1
V2 V3
V4
7. Reset the item DCOL to "1" level.
8. Write into the memory by pressing
then .
V. SIZE ADJUSTMENT ( VSIZ)
1. Input a cross-hatch signal.
2. Set to Service adjustment mode.
3. Select VSIZ with
and .
4. Adjust with
and for the best vertical size.
/
?
H. CENTER (VPOS)
/
?
V. CENTER (VPOS)
READ FROM MEMORY
Green
0
SERVICE READ
Red
SERVICE DISP 15
V. CENTER ADJUSTMENT (VPOS)
1.Input a cross-hatch signal.
2.Set to Service adjustment Mode.
3.Select VPOS with and .
4.Adjust with
and for the best vertical center.
5.Write into the memory by pressing
then