Filter
Top Products
Setup and Cable Connections
17
When operating two video devices with the IR
Blaster, set the video devices and the IR Blaster
as shown.
If the infrared receivers on the two video devices
do not line up like the illustration above, you need
to purchase an optional IR Blaster (VM-50, not
supplied) and install it.
Note
For details on setting up a video device, refer to the
operating instructions of the video device.
z Tips
• If the IR Blaster cable is too short, use the 3.5 mm
jack extension cable (not supplied).
• Remote sensors on Sony Recorders and other
products are identified by the symbol.
• You can set up two on-screen remote controls for
each video input connector, except if you add new
buttons to the first remote control by the "Add
buttons" feature. These on-screen remote controls
allow you to operate two video devices connected
directly to the Base Station, and to control video
input via those video devices. For more details, refer
to the LocationFree
®
Player’s Help.
IR Blaster
Remote sensors