Filter
Top Products
Base Station Settings
25
This section explains the operations common to
each frame in the [Base Station Settings] page.
1 Click the item to configure.
The information for the clicked item appears
in the frame on the right.
2 Return to the [Base Station Settings] page.
3 Make settings or perform operations for the
selected item.
If you make any settings, be sure to click [Set]
to save the changes.
The remainder of this section explains the
specific settings and operations of each frame in
the [Base Station Settings] page.
Set the port of the Base Station when the NetAV
function is to be used.
1 If there are multiple Base Stations and 5026 is
already being used, change the port number of
the NetAV server.
You can specify port numbers in the range
5021 to 5999.
At the time of purchase this item is set to 5026.
2 Select whether to enable or disable automatic
updating for the Dynamic DNS. At the time of
purchase, this is set to [Enable]. If [Enable] is
set, the automatic NetAV check is performed
on the same occasion.
3 Select whether to enable or disable automatic
router configuration (UPnP).
When [Disable] is set, port forwarding needs
to be set on the router.
At the time of purchase, this is set to [Enable].
4 Click this to save changes.
Setting a Router Incompatible with
the UPnP Function
Select to disable automatic router configuration
(UPnP) in the NetAV settings, and when port
forwarding needs to be set on the router, follow the
procedure below to set the Base Station’s IP address.
z Tip
The IP address, subnet mask, and default gateway used
in the following procedure are only examples. Before
you configure these settings, check the IP address
settings of the router.
1
Set [IP Address Settings] to [Manual] in the
[Internet Connection] frame and then enter
the following information (1 page 26).
IP Address: 192.168.0.64
*1
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.0.1
*2
*1
Example when the IP address of the router
is 192.168.0.1. If the IP address of the
router is 192.168.1.1, enter 192.168.1.64
for the IP address. If you are using multiple
Base Stations, set a different setting for
each Base Station, such as 64 and 65.
*2
Example when the IP address of the router
is 192.168.0.1. If the IP address of the
router is 192.168.1.1, enter 192.168.1.1
for the default gateway.
Basic Operations in the [Base
Station Settings] Page
NetAV Settings
1
3
2
1
4
3
2