Filter
Top Products
Setting Up the SXRD Projection TV
42
SXRD
2-584-141-12(1)
VCR and Cable Box Use this hookup if:
❑ Your cable TV company scrambles some channels, but not all of them
(pay channels vs. regular cable channels) and you need to use a cable
box.
❑ You want to enjoy the Twin View feature.
With this setup you can:
❑ Use the SXRD projection TV’s remote control to change channels on
your cable box when the signal is scrambled. To program your Sony
remote control to operate your cable box, see “Programming the
Remote Control” on page 64.
❑ Use the SXRD projection TV’s remote control to change channels on
your SXRD projection TV when the signal is not scrambled. Your
SXRD projection TV’s tuner provides a better signal than the cable box.
❑ Use the Twin View feature. (When all channels are routed through your
cable box, only one signal is sent to the SXRD projection TV, so you
cannot use the Twin View feature.)
Disconnect all power sources before making any connections.
1 Connect the CATV cable to the single (input) jack of the splitter.
2 Using a coaxial cable, connect one of the splitter’s two output jacks to
the SXRD projection TV’s CABLE jack.
3 Using a coaxial cable, connect the splitter’s other output jack to the
cable box’s input jack.
4 Using a coaxial cable, connect the cable box’s output jack to the VCR’s
RF input jack.
5 Using an A/V cable, connect the cable box’s A/V output jacks to the
SXRD projection TV’s A/V input jacks.
6 Using an A/V and S VIDEO cables, connect the VCR’s AUDIO and S
VIDEO OUT jacks to the SXRD projection TV’s AUDIO and S VIDEO
IN input jacks.
7 Run Auto Program, as described in “Setting Up the SXRD Projection
TV Channel List” on page 60.
Before connecting a cable
box, see “Using
CableCARD” on page 58.
✍ To view scrambled channels, tune the SXRD projection TV to the channel
the cable box is set to (usually channel 3 or 4) and then use the cable
box to switch channels.