Filter
Top Products
40
The VIDEO Plus+ system is a feature that
simplifies setting the timer. Just enter the
PlusCode programming number listed in the
TV programme guide. The date, time, and
programme position of that programme are
set automatically.
Check that the programme positions are
correctly set in “Channel Setting” in the
“Basic” setup (page 57).
1 Press TIMER.
2 Select “PlusCode No.” using M/m,
and press ENTER.
3 Press the number buttons to enter the
PlusCode programming number, and
press ENTER.
The date, start and stop times,
programme position, recording mode,
etc. setting (page 38) appear.
• If you make a mistake before pressing
ENTER, press </, and re-enter the
correct number.
• If you want to change the setting, press
</, to select the item and press M/m
to change the setting.
• If you want to re-enter the PlusCode
programming number, select
“PlusCode No.,” and press ENTER.
Then re-enter the PlusCode
programming number.
4 Select “OK,” and press ENTER.
The TIMER REC indicator lights up on
the front panel, and the recorder is ready
to start recording.
To stop recording during timer recording
Press x REC STOP.
Note that it may take a few seconds for the
recorder to stop recording.
If the timer settings overlap
See page 39.
To extend the recording duration time
while recording
See page 39.
To confirm, change, or cancel a timer
recording
See “Checking/Changing/Cancelling Timer
Settings (Timer List)” on page 42.
z Hint
The Rec Mode Adjust function also works with this
timer method (page 38).
Recording TV programmes
using the VIDEO Plus+ system
</M/m/,,
ENTER
TIMER
Number
buttons
x REC
STOP
z REC