Sony RDR-HX1010 DVD Recorder User Manual


 
100
TV Pause does not work.
, You are recording to the HDD or the HDD is full.
The programme position cannot be changed
from the programme position you are
recording.
, Set the TV’s input source to “TV.”
Recording does not start immediately after you
press z REC.
, Operate the recorder only after “LOAD,”
“FORMAT,” or “INFOWRITE” disappears
from the front panel display.
Nothing was recorded even though you set the
timer setting correctly.
, There was a power failure during recording.
, The recorder’s internal clock stopped due to a
power failure that lasted for more than 1 hour.
Reset the clock (page 86).
, The channel was disabled after the timer
recording was set. See “Channel Setting” on
page 82.
, Disconnect the mains lead from the mains, and
connect it again.
, “PDC/VPS Scan Off” was selected in the
TOOLS menu (page 44).
, The programme contains copy protection signals
that restrict copying.
, Other timer setting overlapped the timer setting
(page 49).
, There is no DVD inside the recorder.
, There is not enough disc space for the recording.
, The recorder was in the process of DV Dubbing.
Recording does not stop immediately after you
press x REC STOP.
, It will take a few seconds for the recorder to input
disc data before recording can stop.
Recording does not stop after you press x.
, Open the remote’s cover and press x REC
STOP.
Timer recording is not complete or did not start
from the beginning.
, There was a power failure during recording. If
the power recovers when there is a timer
recording, the recorder resumes recording.
Should the power failure continue for more than
1 hour, reset the clock (page 86).
, Other timer setting overlapped the timer setting
(page 49).
, Disc space was not enough.
, The PDC/VPS function is working.
Contents previously recorded were erased.
, Data that has been recorded on a DVD with a PC
will be erased from the disc when the disc is
inserted.
, “Auto Title Erase” in the TOOLS menu (appears
when you press TOOLS while the Timer List
menu is turned on) is set to “On” (page 50).
, The title was updated and recorded over
(page 43).
The PDC/VPS function does not operate.
, Check that the clock and date are set correctly.
, Check that the PDC/VPS time you set is the
correct one (there might be a mistake in the TV
programme guide). If the broadcast you wanted
to record did not send the good PDC/VPS
information, the recorder will not start recording.
, If the reception is poor, the PDC/VPS signal
might be altered and the recorder might not start
recording.
, “PDC/VPS Scan Off” is selected (page 44).
Nothing was recorded even though you set the
Synchro-Rec setting correctly.
, You forgot to turn off the connected equipment.
Turn off the connected equipment and set the
recorder to Synchro-Rec standby mode
(page 50).
, The recorder was not set to the Synchro-
Recording standby mode. Press SYNCHRO
REC to have the recorder stand by for recording.
Make sure the SYNCHRO REC indicator lights
up on the front panel (page 50).
, The recorder is connected to the TV output jack
of the connected equipment.
Recording/Timer recording/
Editing
Recording from the equipment
with a timer