Filter
Top Products
100
The MP3 audio tracks do not play.
, The MP3 audio tracks are not recorded in a
format that the recorder can play (page 59).
The JPEG image files do not play.
, The JPEG image files are not recorded in a
format that the recorder can play (page 59).
, Progressive JPEG images cannot be played.
TV Pause does not work.
, You are recording to the HDD or the HDD
is full.
The programme position cannot be
changed from the programme position you
are recording.
, Set the TV’s input source to “TV.”
Recording does not start immediately
after you press z REC.
, Operate the recorder only after “LOAD,”
“FORMAT,” or “INFOWRITE” disappears
from the front panel display.
Nothing was recorded even though you set
the timer setting correctly.
, There was a power failure during recording.
, The recorder’s internal clock stopped due to
a power failure that lasted for more than 1
hour. Reset the clock (page 86).
, The channel was disabled after the timer
recording was set. See “Channel Setting”
on page 82.
, Disconnect the mains lead from the mains,
and connect it again.
, “PDC/VPS Scan Off” was selected in the
OPTIONS menu (page 43).
, The programme contains copy protection
signals that restrict copying.
, Other timer setting overlapped the timer
setting (page 48).
, There is no DVD inside the recorder.
, There is not enough disc space for the
recording.
, The recorder was in the process of dubbing
(HDDyDVD).
, The recorder was in the process of DV
Dubbing.
Recording does not stop immediately
after you press x REC STOP.
, It will take a few seconds for the recorder to
input disc data before recording can stop.
Recording does not stop after you press
x.
, Press x REC STOP.
Timer recording is not complete or did not
start from the beginning.
, There was a power failure during recording.
If the power recovers when there is a timer
recording, the recorder resumes recording.
Should the power failure continue for more
than 1 hour, reset the clock (page 86).
, Other timer setting overlapped the timer
setting (page 48).
, Disc space was not enough.
, The PDC/VPS function is working.
Contents previously recorded were
erased.
, Data that is not playable on this recorder but
was recorded on a DVD with a PC will be
erased from the disc when the disc is
inserted.
, “Auto Title Erase” of the “Timer Settings”
in the “Recording” setup is set to “On”
(page 92).
The PDC/VPS function does not operate.
, Check that the clock and date are set
correctly.
, Check that the PDC/VPS time you set is the
correct one (there might be a mistake in the
TV programme guide). If the broadcast you
wanted to record did not send the good
PDC/VPS information, the recorder will not
start recording.
, If the reception is poor, the PDC/VPS signal
might be altered and the recorder might not
start recording.
, “PDC/VPS Scan Off” is selected (page 43).
Recording/Timer recording/
Editing