Filter
Top Products
C:\2886042111HXD860CEK\01GB-
HXD860CEK\110OTH.fm
master page=right
specdef 20060621
RDR-HXD860
2-886-042-11(1)
85
DV Dubbing
3 Press INPUT SELECT on the remote
repeatedly to select “DV.”
The front panel display changes as
follows:
4 Press REC MODE on the remote
repeatedly to select the recording
mode.
The recording mode changes as follows:
For details about the recording mode, see
page 45.
5 Press OPTIONS on the remote to
select “DV Audio Input,” and press
ENTER. Then, select the setting for the
audio input.
“Stereo1” (default): Records original
sound only. Normally select this when
dubbing a DV format tape.
“Mix”: Records both stereo 1 and 2.
“Stereo2”: Records additional audio
only.
Select “Mix” or “Stereo2” only if you
have added a second audio channel when
recording with your digital video camera.
You are ready to start dubbing. Select
one of the dubbing methods on the
following pages.
6 Adjust the dubbing picture quality and
size.
Before dubbing starts, press OPTIONS
to select “Rec. Settings,” and adjust the
recording settings (page 52).
z Hint
You can turn off the recorder during dubbing. The
recorder completes dubbing even after being turned
off.
b Notes
• You cannot connect more than one piece of
digital video equipment to the recorder.
• You cannot control the recorder using another
device or another recorder of the same model.
• You cannot record date, time, or the contents of
the cassette memory onto the disc.
• If you record from a DV/Digital8 format tape that
is recorded in multiple sound tracks, such as a
tape with multiple sampling frequencies (48 kHz,
44.1 kHz, or 32 kHz), no sound or an unnatural
sound will be output when playing back the
sampling frequency switch point on the disc.
• In order to use this recorder’s “Auto Chapter”
setting (page 86, 87), be sure to correctly set the
clock on your digital video camera before
shooting.
• The recorded picture may be momentarily
affected or the start and end points of a title may
be different from what you have set if the source
DV/Digital8 format tape is in any of the following
conditions. In this case, see “Recording from
connected equipment without a timer” (page 58).
– There is a blank space in the recorded portion of
the tape.
– The tape’s time code is not sequential.
– If the picture size or the recording mode on the
tape being dubbed changes.
programme
position