Filter
Top Products
14
5 Press the four-digit component
code number followed by the
ENT key on the touch-key
display.
Example: To enter “8086”
Input “8,” “0,” “8,” “6,” and press
“ENT”.
If you press the CLEAR key during
inputting the digits
Input digits are cancelled. The four-
digit component code number
previously set is displayed, and the
cursor returns to the first digit.
When the setting of the code
succeeded
The selected component name, the
preset four-digit component code
number and “OK” light while a beep
sounds. And the display returns to
Step 3.
Setting the Code for Preset Audio
and Visual Components
(continued)
6 If you want to set a code for
another component, repeat Steps
4 and 5.
7 Press COMMANDER OFF.
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the
previous setting mode.
Notes
• If you press a component code number that is
not on the table in the supplied “Component
Code Numbers”, the Commander beeps five
times and “NG” flashes after you press the
ENT key. The setting returns to the previous
one. If this happens, check the component
code number, and try setting again.
• If you don’t input anything into the
Commander for over two minutes between
each step, the setup procedure will be
cancelled. To set the code, you must again
press % while pressing COMMANDER OFF.
• The first digit of the component code number
means the component category (TV, VCR,
etc.). The component corresponding to the
four-digit component code number is preset
in Step 5. If you preset the component of
which category is different from that preset
previously to the Component Select button or
the Label key, you can, if necessary, change
the component names on the Mode Display
key or the Label keys (see page 79).
• If you preset a component code after you
input character contents to the Mode Display
key (page 24) or the Label keys (page 23),
they are cleared and return to the original
display. Edit the characters after you decide
the component to be used by presetting a
code.
COMMANDER
OFF