Filter
Top Products
55
5 Press the “ENTER” key.
During transferring the data,
“
c
c
c
c
” flashes.
When the data has been successfully
transferred, “END” appears on the
right Label key.
Note
If “NG” appears while sending the data, go
back to Step 6 and continue the operation
or press COMMANDER OFF to stop the
operation.
6 Press COMMANDER OFF.
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the
previous setting mode.
Notes
• The data of the System Control function
programmed for a Component Select button
cannot be transferred.
• Be sure that the receiving Commander is
ready to receive data.
TV
“COMPO X” appears on the Mode
Display key, and the selected
component name appears on the left
Label key.
3 Press the Component Select
button of which data you want to
send.
Or press the Label key of which data
you want to send. (To change the
Label keys, press the OTHER button
repeatedly.)
The component name of which
contents are to be transferred appears
on the left Label key.
4 Confirm that the receiving remote
commander is ready to accept
data.
(To set the receiving commander,
follow the procedure on page 56.)
COMMANDER
OFF
Continued