Filter
Top Products
45
Adding a command that is
required when selecting a
component
In addition to the original function of
selecting the operating keys and buttons
of the desired component, the
Component Select button or the Label
key can have another remote control
signal by “learning.”
For example, if you always have to
change input select of the amplifier to CD
when listening to the CD player,
programme the signal of “changing the
amplifier’s input select” to the CD button
of this Commander. Then whenever you
press the CD button, it automatically
works as the original CD Component
Select button and changes also the
amplifier input select to CD. (In this case,
the amplifier should be turned on first.)
Note
Some specific remote control signals may not
be learned.
MENU EXIT
COMMANDER
OFF
MORE321
TV STB VCR DVD CD AMP
OTHER
TIMER
SYSTEM CONTROL
OK
3
5
PROGRAM
Continued
Notes
• If the component code of a non-Sony product
has been set for a Component Select button
or a Label key, you cannot programme the
Power-On function for it.
• Even if you have programmed a signal by
“learning” (See “Adding a command that is
required when selecting a component”, page
45) or a System Control function (page 38) for
a Component Select button or a Label key,
you can programme the Power-On function
for that button, but it cannot be used. If you
clear a “learned” signal or the System Control
function from the button or key, you can use
the Power-On function.
• You can programme a signal by “learning”
(page 45) or a System Control function (page
38) for a Component Select button for which
the Power-On function has been
programmed. In this case, the Power-On
function is overwritten and cannot be used. If
you clear the “learned” signal or the System
Control function from the button or key, the
Power-On function is resumed, and you can
use it again.
• You can set the learning function (page 46) or
the System Control function (page 31) to the
Component Select button or the Label key for
which you programmed the Power-on signal.
In this case, the Power-on setting is also
available and the Power-on signal is output.
So check the setting of Power-on signal
before setting the learning function or the
System Control function.