Filter
Top Products
60
Note
You cannot programme the Channel Macro
function for a macro key that has “learned” a
signal. Try again with another macro key, or
clear the “learned” signal (page 25) from the
button and programme the Channel Macro
function on it.
To clear the Channel Macro
function
1 While pressing COMMANDER OFF,
press %.
2 Press the SET key.
3 Press the CHMACRO key.
4 Select the component by pressing the
Component Select button or the Label
key.
5 While pressing the DEL key, press the
macro key.
Note
You can also clear the character contents you
input by following the procedure above
repeatedly.
COMMANDER
OFF
Selecting a Programme with a
Single Key Press — Channel Macro
Function (continued)
If you press the Label key for
which the Channel Macro function
cannot be programmed
“NG” flashes twice and “NG” sound is
heard.
To change the name of the macro
key (Label key)
Keep the macro key (Label key) pressed for
more than 2 seconds, and follow Steps 2 - 5,
page 24.
6 Press the keys for the operation in
order (1t 2 t 3).
Note
If you enter more than 5 keys, the last
5 keys are programmed for the macro
key.
7 Press the macro key (in this case,
BLUE).
“1,” “2,” and “3” appear twice.
8 Press COMMANDER OFF.
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the
previous setting mode.