Filter
Top Products
16
Installing and Connecting the TV
Connecting a DVD Player with Component Video
Connectors
This is the preferred hookup to use if:
•Your DVD player has component (Y, P
B, PR) jacks.
Disconnect all power sources before making any connections.
1 Using a component video cable, connect the DVD player’s Y, PB and PR
jacks to the Y, PB and PR jacks on the TV. Use the VIDEO 3 IN
connections.
Tip
The Y, PB and PR jacks on your DVD player are sometimes labeled as Y, CB and CR, or Y,
B-Y and R-Y. If so, connect the cables to the matching colors.
2 Using an AUDIO cable, connect the DVD player’s AUDIO OUT jacks to
the TV’s AUDIO IN jacks.
Note
The Y, PB and PR jacks do not provide audio, so audio cables must be connected to
provide sound.
Tips
• To take advantage of the Wide Screen Modes, set the aspect ratio of the output signal to 16:9
on your DVD player. For details, refer to the operating instructions supplied with your DVD
player.
• Some DVD players are equipped with the three component video connectors: Y - Green, P
B
(CB, Cb or B-Y) - Blue and PR (CR, Cr or R-Y) - Red.
Rear of TV
P
R
PB
Y
AUDIO cable
(not supplied)
Component
video cable
(not supplied)
DVD player
AUDIO-L
(white)
AUDIO-R
(red)