Filter
Top Products
16
Names and Functions of Controls on Screen
1.4 OUTPUT Screen
You can set the parameters of the output block of the SRP-X700P from the OUTPUT screen.
1.4.1 OUTPUT OVERVIEW Screen
This screen corresponds to the output module of the audio mixer. This screen enables you to set the following.
The OUTPUT 1 through OUTPUT 8 correspond to the LINE OUTPUT 1 through LINE OUTPUT 8 of the main unit.
1 OUTPUT index
Displays the index that is input on the BLOCK screen.
2 OUTPUT level meter
Displays the output signal level by the VU response.
3 REF LEVEL selection box
You can set the reference output level for each output channel.
You can set it to –10, –5, 0 or +4 dBu for OUTPUTs 1 and 2.
You can set it to –10, –5 or 0 dBu for OUTPUTs 3 to 8.
4 Setup... button
By clicking the Setup button, the display jumps to the
OUTPUT EQ screen where you can set the various
equalization functions as shown below.
5 EQ (EQualizer) button
Turns on and off the equalizer.
The EQ (EQualizer) button lights in green when the EQ button
is pressed ON.
6 HCF (High-cut Filter) indicator
The HCF indicator lights in green when the high-cut filter is
pressed ON.
7 DELAY button
Turns on and off the delay function.
The DELAY button lights in green when the delay is pressed
ON.
8 DELAY value setup box
You can set the delay time value from this setup box. Clicking
the v or V button allows you to set the DELAY value in
2.9-ms steps in the range of 0ms to 150.8 ms. Alternatively,
you can set DELAY in 1-m steps in the distance range of 0m
to 52 m, or in 3.33-ft steps in the range of 0 ft to 173.3 ft. You
can also enter numerical values directly in the setup box. To
switch the units, use the 9 DELAY UNITS setup box.
9 DELAY UNITS setup box
The DELAY UNITS setup box allows you to select the unit of
the delay as shown below. Clicking the DELAY UNITS setup
box indicates the units. Select the desired unit.
• In units of time: ms
• In units of distance: meter, feet
0 MUTING button
Mutes the output signals of the respective channels. The
MUTING button lights in red when muted.
qa GAIN LIMIT and qs OVER GAIN indicator
The output level of the output channel is the sum of the SRP-
X700P master volume on the GROUP FADER screen and the
remote control via the remote terminal on the REMOTE
screen.
You can set the upper limit of the output level by the
qa GAIN LIMIT to prevent excessive output level caused by
using multiple volume controls. Each click of the [+] or [--]
button increments or decrements the output level by 1 dB in
the range of +10 dB to –10 dB. You can enter numerical values
directly on the screen.
If the output level exceeds the GAIN LIMIT value, the actual
output level is limited to the GAIN LIMIT value and the
qs OVER GAIN indicator lights in red.
qd
–
∞ indicator
If there is no output sound when muted or when the OUTPUT
fader is at the
–
∞ level position, the
–
∞ indicator lights in
yellow.
qg qj wa
wfwdwg
wsqh
9qlw;
qf
qd
7
0
qs
3
qk
4
6
8
5
2
1
qa