Filter
Top Products
17
qf OUTPUT fader
You can adjust the OUTPUT fader by dragging the fader
portion.
The yellow marker displayed on the side of the fader indicates
the fader position that is the addition of the OUTPUT fader setup.
When the sound volume of a specific input channel is to be set
from the REMOTE screen and the GROUP FADER screen,
the fader position determined by the SRP-X700P Master
volume control and the remote control signal via the
REMOTE terminal is indicated.
(The fader level at the yellow marker position in Fig. 2 is the
–15 dB position.)
Power Amplifier Block
ql Operation mode setup box
Selects one of the following modes depending on the type of
speaker to be connected.
Lo Imp.: A low impedance (4 Ω to 16 Ω) speaker is to be
connected.
70 V LINE: A high impedance (32 Ω to 10 kΩ) speaker is to
be connected.
In the case of 70 V LINE, the channel 1 setup becomes valid
for the selectors and attenuators.
w; PROTECTION indicator
The PROTECTION indicator lights in red when the internal
power amplifier protection circuit operates.
Note
When the PROTECTION indicator lights
The protection circuit operates (PROTECTION indicator lights)
and the speaker and amplifier are protected from damage by
decreasing or cutting the output signal in case of the following:
• If the temperature of the heat sink inside the amplifier
exceeds the specified value.
The connected speaker impedance is too low.
Air intake and air exhaust holes (on the right and left sides of
the SRP-X700P) are choked by dust.
• The SPEAKER terminal is short-circuited.
In such a case, turn the POWER switch to the OFF position
and remove the cause of the fault before using the unit again.
• If DC voltage appears in the SPEAKER terminal due to failure.
Turn off the POWER switch and contact your Sony
representative where you purchased the unit or contact your
local Sony Sales office or Dealer.
wa SPEAKER OUTPUT index
Displays the index that is entered on the BLOCK screen.
ws SELECT setup box
Selects the input signal to the internal power amplifier. When
the 70V LINE is selected, the channel 1 setup only is valid.
wd ATT
Adjusts the output level for the internal power amplifier.
Clicking the [+] or [--] button increases or decreases the output
level in the range of 0 dB to ∞ dB. When the 70 V LINE is
selected, you can adjust channel 1 only. ATT is set at the
10 dB position for ordinary use.
wf SPEAKER OUTPUT MUTING button
Mutes the speaker output. The SPEAKER OUTPUT
MUTING button lights in red when muted. When the 70V
LINE is selected, the channel 1 only can be operated.
wg CLIP indicator
The CLIP indicator lights in red when the internal power
amplifier clips. Adjust the output level using wd ATT so that
the CLIP indicator does not light frequently.
qg REC OUT index
Displays the index that is entered on the BLOCK screen.
qh REC OUT level meter
Displays the output signal level using the VU response.
qj REC OUT REF LEVEL selection box
You can set the reference output level for every output channel
on this selection box.
You can select –10, –5 or 0 dBu as the REC OUT level.
qk REC OUT MUTING button
Mutes output signals of the respective channels. The REC
OUT MUTING button lights in red when muted.
–
∞
–25
–15
–5
0
+5
+10
–
∞
+10
0
–
∞
–25
–15
–5
0
+5
+10
ROUTING OUTPUT
OUTPUT fader
on the OUTPUT
OVERVIEW
screen
REMOTE1
to
6
of the GROUP
FADER screen
Signal flow
MASTER volume
of the SRP-X700P
Fig. 2