Filter
Top Products
Section 6.7 - Punch operations
6-8
• The tape will locate to the punch pre-roll point
and start playing. The
INPUT MONITOR
indicators of the armed tracks will go out,
showing that monitoring is off-tape.
• When the tape reaches the punch-in point, the
RECORD
key [40] will light, and the
RECORD FUNCTION
indicators of the
armed tracks will also light steadily.
•The
INPUT MONITOR
indicators will light,
showing that source monitoring is now
enabled.
• When the tape reaches the punch-out point, the
RECORD
key will go out and the
RECORD
FUNCTION
indicators of the armed tracks
will start to flash. The
INPUT MONITOR
indicators will also go out .
• When the tape reaches the post-roll point, it
will stop.
• To repeat the take, press the
AUTO
PUNCH
key again.
• The take can be interrupted at any time by
pressing the
STOP
key.
• Check the punched material by pressing the
PRRL
key and locating to the punch pre-roll
point . If the
AUTO PLAY
indicator is lit while
the pre-roll location is taking place, playback
will start automatically when the pre-roll point
is reached.
NOTE
When you are satisfied with the take, remember to turn off
the
AUTO MON
setting and unarm the tracks.