Filter
Top Products
10.1 - Menu groups
10-5
Menu group 7
Menu group 8
Menu item Parameter(s) Values Reference
MTC Output
Output
Fast wind mode
Stop
(All parameters ) on, off
on
, off
on, off
8.2.7, “MIDI Time-
code output”
MIDI/Bus ID
ID for MMC
and bus control
001 through 127 or Receive
All
9.4.9, “MMC ID”
9pin Locate Pre-
roll
Preroll time for
P2 device
00min00sec through 59min59sec in
1 second increments
9.3.2, “Location pre-
roll on the serial
unit”
9pin Control
Mode
Recording status
when using P2
device
Split, Normal
9.3.4, “Split mode
on the serial unit”
9pin Time Mode
Time source for
P2 device
Timecode, Timer 1
9.3.3, “Serial unit
timing source”
9pin Rec Accept-
able
Record enable
for P2 device
On, Off 9.3.5, “Controlling
recording opera-
tions on the serial
unit”
Menu item Parameter(s) Values Reference
Generate Start
Time
Time value
Defaults to 00:00:00:00
8.1.4, “Setting the
generator start time”
Generate Mode
Run/Stop
Mode
Stop, Run
Reset
, Continue
8.1.5, “Starting and
stopping the genera-
tor”
Fs Shift Mode
Pull up/down
parameters
off, Pull Down 30NDF,
Pull Up 29.97NDF, Pull Up
29.97 DF
, Pull Down 30 DF
( only)
8.2.3, “Pull up and
pull down”
TC Record Source
Source to be
used for record-
ing on the time-
code track
External TC,
Generator
TC
, Tape
a
a. If Tape is selected, another parameter will automatically be appended, depending on the setting made in the appropriate
menu, as described in 8.1.1, “Selecting the timecode source”
8.1.1, “Selecting the
timecode source”
TC Track Record
Arming the
timecode track
enable, disable
8.1.7, “Recording
the timecode on a
DTRS timecode
track”
M T C O u t M I D I I D
9 p i n L o c P r 9 p i n C t l M d
9 p i n T i m M d 9 p i n R e c A c
98
98
G e n S t a r t F s S h i f t
G e n M o d e T c R e c S r c
T c T r k R e c
9888
9888
9888
98
98
9888