Filter
Top Products
English - 6 -
Inserting Batteries in the Remote Control
• Remove the battery cover located on the back of the
remote control by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 (2 X 1.5Volt) or equivalent type batteries
inside. Place the batteries in the right directions observing
the polarity symbols (+/-) and replace the battery cover.
• While using the remote control, you should direct it
towards the front panel of the receiver. Remote range is
approximately 7m/23ft.
• If your receiver no longer responds to the remote control.
it is probable that the batteries are exhausted. If so you can
still use the local buttons of the receiver. You can replace
batteries after they are exhausted. Please use only the leak
proof batteries.
Note : Remove the batteries from the remote control
when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of
batteries.
Connecting the Set-Top Box to a TV Set
You can connect your set top box to a TV by using the following methods:
1. HDMI connection: If your TV has an HDMI input, you can simply connect the set top box to your TV by
using an HDMI cable between the HDMI OUT connector on your Set-Top Box and the HDMI INPUT connector
on your TV. HDMI connection provides a better picture/sound quality.
2. SCART connection: You can also connect the set top box to your TV by using the scart socket. Use a
scart cable to connect the set-top-box to your TV.