Filter
Top Products
English - 7 -
Power Connection
IMPORTANT: The set-top box is designed to operate on 12V DC. For this, an adaptor is used
which supplies a 12V DC voltage. Connect this adaptor to a mains socket that supplies
220-240V AC,50Hz.
• After unpacking, allow the set-top box to reach the ambient room temperature before you plug in to the
mains for the rst time .
Antenna Connection
This illustration shows how to connect an antenna.
• Use ANTENNA IN to connect to an antenna system.
• You can also use TV OUT to connect antenna to your TV through the set-top-box with an appropriate
antenna cable,
Power On-Off
• After plugging the set-top-box into the mains supply, a light will be seen on the front panel (Standby mode).
• When the set-top-box is rst powered up please wait until the box is initialised. This will take a few
seconds.
• Afterwards, you can switch on your digital set-top box by pressing the standby button on the remote control.
You will see that the light on the front panel will go out (Power on mode).