Filter
Top Products
Remote control
21
EN
EN
Programming the remote control
If your remote control does not control your satellite receiver (or cable) or your television set
you will need to configure it using one of the two methods proposed: automatic code search or
manual programming.
Automatic code search
This method can be used to automatically find the most appropriate code for
your appliance.
1. Switch on the appliance you wish to use the remote control with.
2. Press the relevant key for this appliance on the remote control, and while
holding this key down, press the standby key until the remote control
light comes on. Release the two keys.
3. Point the remote control at the appliance and press PLAY.Wait until the
light stops flashing. If the appliance has not gone into standby mode after
five seconds, press the
PLAY key again to continue the search for the
next set of codes. Repeat this operation until the appliance goes into
standby mode.There are 20 sets of codes.
4. When the appliance goes into standby mode, press the key on the
front to switch it on again.Then press the
REV key to put it back in
standby mode, and if necessary,keep pressing until the appliance goes into
standby.
5. Press the STOP key and hold it down until the remote control light goes
off.
Manual programming
This method involves carrying out a manual search for the codes to be used
for controlling your other appliances.
1. Switch on the appliance you wish to use the remote control with.
2. Press the corresponding key on the remote control, while holding it
pressed down, enter one of the codes corresponding to the brand of the
device (Thomson Group codes on the bottom left of this page, other
brands can be found in the “Related documents” leaflet).
If the remote control light flashes you have entered the wrong code or it is not
possible to program the remote control.
3. Point the remote control at the appliance and press the relevant key.
Press the standby key.
If the appliance does not go into standby mode, try another code.
Depending on the year of manufacture and the type of appliance, some functions
may not be available.
Certain codes may cover more functions than others.Test the functions you
can control and, if appropriate, try other codes.
Note here the code(s) which work best.
Note: when you change the remote control’s batteries, remember to reprogram it.
TV
SAT•CABLE
SAT Codes: 5000, 5001,
5031, 5037, 5043, 5064,
5065, 5066, 5058, 5084.
TV Codes:
1000, 1001,
1002, 1016, 1024, 1033,
1041, 1051, 1089, 1096,
1127, 1128, 1129, 1130,
1134, 1135, 1148, 1151.
DTH7500_en 4/07/03 16:55 Page 21