Filter
Top Products
Menus
49
EN
EN
AV1 output
Choose the RGB, S-Video or Video signal, depending on the device
connected to the AV1 Scart socket (usually TV sets). If you don’t know which
type of signal is accepted by your TV set, try each setting to get the best
result.
Note: transmission of DMR images to TV images (with certain TV sets)
If you want to watch one channel while recording programmes on another channel, you
must change the AV1 output connection setting by selecting Video instead of RGB
in the Options menu.
AV2 Input
Choose the RGB, S-Video or Video signal, depending on the device
connected to the AV2 Scart socket (usually a satellite receiver). If you don’t
know which type of signal is accepted by your TV set, try each setting to get
the best result.
Note: format of image signals:
RGB: English signal colour code (Red – Green – Blue).
S-Video: S-VHS (Y/C), signals with separate colour components and brightness.
Video: CVBS, composite video signals.
Standby mode
Your DMR has an Eco Standby to reduce its power consumption when on
stand-by.Select Eco standby to enable this function.
Note: the Eco standby function does not allow the display of programming warning
messages on the display panel. Only the record icon will flash.
Pause Time
To select the memory capacity of the Pause Live TV option (45 minutes
or 1h30).
Other settings
1. From the main menu select the Setup line with the keys, then confirm with OK.
2. Select Installation with the keys, then confirm with OK.
3. Select a function with the keys, confirm with OK, adjust and confirm with the keys
and
OK.
AV link
Permits a television to control your DMR and download the same channels
on the same numbers.
Note: this function is positioned by default on On.
AutoClock
Allows your DMR to always be set at the correct time, date and day.
Note: leave this function activated to avoid any problems when programming recordings
DTH7500_en 4/07/03 16:56 Page 49