Filter
Top Products
30
Recording functions
6. Start time and stop time
Enter the recording start time and then the stop time.
To this end, and according to the features of the receivers, you must:
- either program the receiver with the same beginning and end times, then switch off the
DVD recorder and the receiver,
- or leave the satellite receiver switched on, on the channel to record, program the
DVD recorder, then switch it off.
Note: if you selected AV2 during step 4, you do not need to enter the start and stop times, since it is the
device that is connected that triggers the start and stop of the recording at the times set via its
programming menu.
7. Recording quality
Select a recording quality from the 6 proposed using the key.
*1: Best, *2: High, *3: Good,*4: Normal, *5: Basic, *6: Low.
Note: the choice of quality allows an adaptation to the remaining
recording time on a DVD disc.The lower the quality is, the more
space there will remain on the disc. For example the time
available on a blank DVD disc of 4.7 Gb in “Low” quality is
around 8 hours, while in “Best” quality the time will only be
around 60 minutes.The figure 1 to 6 is displayed in the
information banner when playing the recording.The quality choice
is only valid for one particular programming session.
For an automatic quality setting in relation to the time remaining
on the disc, activate the SmartRecord™ function (page 59).
8. VPS/PDC
Activate the VPS/PDC function using the key to trigger recording at the actual time of
the beginning of the broadcast. If the channel broadcasts VPS/PDC signals you can avoid the
consequences of any delays in broadcasting.This adjustment is only valid for this programming
session and for channels received via the aerial (
PR
- -
).
9. Keep Timer
Memorise your programming by selecting Keep Timer with the key and confirming with
the
OK key.
• The Programming screen reappears.Your programming is now displayed in the chronological
list of programming already carried out. On this screen it is only possible to display 5
programming sets from the maximum 8. If you have carried out more than 5 programmings,
to see the others press the or key.
Note: to check (or delete) programming parameters, select a
name and press OK.The programming parameters menu
appears. Correct the parameters as shown in steps 1 to 9 or
delete the programming by selecting Cancel Timer and
confirming with the OK key.
10. Return to the main menu using the MENU key in order to continue to use your DVD
recorder or turn it off using the
ON/STANDBY key, after having loaded a DVD+R or
DVD+RW disc with remaining time compatible with your programming.
2_DTH8060_en.qxd 17/08/05 12:22 Page 30