Filter
Top Products
MENU OPERATIONS
35
H . Motor Control
- Goto : Move the motor to the stored position of the selected satellite.
- Store : Store the current position of the motor for the selected satellite.
* The followings are available only at the Installer mode.
- Recalculate : Recalculate the position of the Stab Rotor motor.
- Goto Ref : Go to reference.
- Limit E , Limit W : Set the limits of East and West position.
- Limit Off : Remove the limitation.
- Reset : Reset all the stored position of the motor relative to the “0” position
I . Service Search
After saving the DiSEqC configuration at the highest signal quality, press OK button to
start service searching of the selected satellite.
USALS Setting
USALS is very convenient motorized DiSEqC system that supports DiSEqC 1.3
command and also can get the satellite position automatically if you know your
geographical location. Basically, the listed satellites have its Longitude and therefore the
angle of the satellite can be calculated without problem.
If you have USALS motorized system, then you can use the USALS as followings.