Filter
Top Products
94 Firmware Update
1. Turn off the target digital receiver.
2.
Plug one end of a RS-232 cable (9 pin D-
sub cable) into the RS-232 port on the dig-
ital receiver, and the other end into the
matching port on the other digital receiver.
3.
Turn on the source digital receiver if not
already on.
4.
Select the Installation
>
Transfer Firmware
>
Transfer Firmware to Other IRD menu,
then you get asked for confirmation; select
Yes.
5.
Turn on the target digital receiver to start
the firmware transfer.
6.
A progress bar appears showing the
progress of the firmware transfer.
7.
Restart the target digital receiver when the
firmware transfer is complete.
10.5 Over the air
You can get a new firmware over
the air.
Select the Installation
>
Firmware Upgrade menu.
You should see a screen like the
left figure.
Selecting the Start command
starts firmware update.