Filter
Top Products
84 Accessing to The Digital Receiver via The Internet
8.2 Configuring the network settings on the digital receiver
You should configure the LAN settings to enable the web ser-
vice and FTP service.
Select the Installation
>
LAN Set-
ting > IP Configuration menu.
You may get the digital receiver to be assigned a dynamic IP
address. Set the DHCP option to On to do that. You can view
the dynamic IP address assigned to the digital receiver by your
router at the LAN Status menu.
Sometimes when the digital receiver is restarted, the dynamic
IP address will be changed and you will have to check it at the
LAN Status menu to access the digital receiver. To avoid this
cumbersome thing, you had better assign a static IP address
rather than dynamic one.
Set the DHCP option to Off, then the IP Address, Subnet Mask
and Gateway options become enabled. You have to set these
options to match with the configuration of your router.
Set the User ID and Password options as you desire. When you
access the FTP server, you will be asked for the account that
was made with these options
NOTE
You can access the FTP server with an anonymous account.
However, with an anonymous account you can only download
files. You cannot upload files.