Filter
Top Products
16 Setup
In this case, you will need to connect a ca-
ble from the RF OUT socket to the antenna
connector onyour television. Toensureyour
television can also pick upexisting analogue
channels as well, you will need to connect a
cable from your television antenna or from
the RF LOOP OUT connector on the back of
the digital receiver to RF IN connector.
2.4.3 Connecting to your video cassette recorder
The digitalreceiveralso can outputvideo toanother appliance
such as video cassette recorder or video receiver through an
auxiliary SCART connector.
You shouldprepare aSCART cableto usethe
auxiliary SCART connector. Plug one end of
the cable into the VCR socket on the digital
receiver, and the other end into the match-
ing socket on yourvideo cassette recorder or
suchlike.
2.5 Inserting batteries in the remote control
To insert the batteries, open the battery compartment by re-
moving the lid, and then insert the batteries observing the po-
larity, which is marked on the base of the battery compart-
ment.
If the digital receiver no longer reacts properly to remote con-
trol commands, the batteries may be flat. Be sure to remove
used batteries. The manufacturer accepts no liability for dam-
age resulting from leaking batteries.
NOTE