Filter
Top Products
70 Recording and Playing
7.4.2 To store a block from a recording
You can store a block from a recording file by performing the
following steps:
1. Start playback of a recording file you want.
2. Press button to display a progress bar.
3. Find one end position of a block you want to specify
with button or button.
4. Press button at the position, then the pointer starts
to blink.
5. Find the other end position.
6. Press button at the position again, then a confirma-
tion box appears.
7. Select the Save command, then the block is stored. The
stored file will named after its source file with a suffix of
‘CUT’ and a number
In addition, you can copy a recording file in whole or in part
when playing back it.
1. Start playback of a recording file you want.
2. Finda desiredposition from whicha copywillbe started
with button or button.
3. Press button.
4. Pressing button stops copying. The copied file will
be named afterits sourcefile with a suffix of ‘COPY’and
a number.
Once a copy is started, a copying symbol like the
next figure will be displayed on the right top of the
screen fora few seconds. To seecopying status, press
button. The outer circle of the copying symbol indicates
progress rate.