Filter
Top Products
14
Manual TV station presetting
Example: Preset the ZDF on program position 2.
1
Select MANUAL TUNING. Then press .
2
Press
or to select PAL or SECAM-L.
Then press ENTER.
3
Press . The auto search starts forward. It will stop at
each station with good reception. Press
again until you
receive the ZDF. Then press ENTER.
4
The channel position number will be highlighted. Press
or repeatedly until the number next to CH change to 2.
Then press ENTER.
The ZDF was now stored in the channel position CH 2.
5
Repeat the steps 2 and 4 to preset other TV stations.
6
Press EXIT to return to the normal screen.
Usually the Automatic station presetting stores all available stations in that particular area.
However, if the reception is poor, some broadcasts may not be stored. If you do want to store
them, you can use the manual tuning procedure described below
: RETURNMENU
PAL CH 2
: SELECT
: SET
ENTER
: RETURNMENU: SET
ENTER
PAL CH 1
: ADJUST
MENU: SET
ENTER
PAL CH 1
: F.TUNING
: RETURN
: SEARCH
: SELECT : ADJUST
: RETURNMENU
AUTO TUNING
MANUAL TUNING
CH ALLOCATION
TELETEXT LANGUAGE WEST
LANGUAGE
VERTICAL POSITION
AUTO 4:3 DEFAULT FULL
: ENDEXIT
Notes:
• The auto search stops at the best
reception for each channel
automatically, so manual fine tuning
is not normally necessary. However
if you wish to, you can manually fine
tune the station - in step 3 when the
auto search has stopped at the
station, press
or until the
desired fine tuning is achieved.
Then press ENTER.
• The search moves up to the next
station position automatically. If you
want to you can also stop the search
manually - press
or at the
desired position and the search will
stop. If necessary you can operate
the fine tuning as described above.
30E2825A_En_P10-17 1/15/07, 8:26 PM14