Filter
Top Products
9
AC INPUT
Antenna connection
Note: Before you connect other appliances:
•To avoid potentially damaging your set, make sure all items are switched off and disconnected from the
mains power when you make the connections.
• Arrange the desired connection.
• When you have finished making the connections, reconnect the mains power to the unit and switch it
back on.
Connect your antenna as shown below (A). Connections to other equipment is explained further on
P.32-34. If you have problems with reception, consult a specialist of antenna.
(A) Outdoor antenna: If the outdoor antenna already exists, you can also connect to it for analog TV-
program.
(B) CATV connection: The built-in Hyperband CATV tuner can receive analogue cable television pro-
grams (this is only applicable in some countries).
(C) HDMI input (HDMI-1/HDMI-2): See P.28.
(D) PC Monitor input (PC): See P.26.
(E) HDMI-1 AUDIO/PC AUDIO (LR) IN jacks: See P.26, 28.
(F) Variable Audio output: To connect to an audio amplifier and external speakers - the audio output
level is varied using the TV’s remote control. You can also disable the TV’s built-in speakers if desired
(see P.20).
(G) COMPONENT input: See P.33.
(H) AV3 input: Input for analogue A/V-Signal (Composite). See P.33.
(I) PHONE jack: Plug headphones with a mini plug (3.5 mm) into this jack.
(J) Scart sockets (AV1/AV2): For the connection of scart cables. See P.32.
(K) Power supply: Connect the supplied power cable to an AC 220-240V/50Hz mains power supply only
- do not attempt to connect it to any other type of supply. Never try to repair a damaged AC power
cord with isolation-tape - this should be repaired by a specialist or replaced. Do not let your pet loose
near the cable. Animals biting into the cable could receive a fatal electric shock, and could cause a
hazard to others.
(L) Bracket holes: Fix a wall mounting bracket (not supplied) here.
(B)
(A)
(L)
(K)
(C)
(D)
(F)
(G)
(H)
(I)
(J)
(E)
Back Side
30E2825A_En_P02-09 07.1.16, 8:23 PM9