Filter
Top Products
16
General controls, time display (ATV only),
stereo/bilingual transmissions
To select a programme position use the numbered
buttons on the remote control.
Programme positions can also be selected using P
e
and
P
f
.
To revert to the previous programme position press
^^
.
To display on-screen information i.e. programme position,
channels, stereo/mono signal, signal strength, date and
time, press . Press again to cancel. The information
shown will vary depending on whether the television is in
DTV or ATV mode.
Press
B
at any time to select between ATV and DTV
modes.
Selecting Programme Positions
The time display facility allows the current (text service)
time to be seen on the television screen.
Press
8
/
9
whilst watching a normal television
broadcast to see a time display from the broadcaster. It
will remain on screen for about 5 seconds.
NOTE: This display may not always be available.
Time Display (ATV only)
i
+
If stereo or dual language broadcasts are transmitted the
word Stereo or Dual will appear on the screen each time
programme positions are changed, disappearing after a
few seconds. If the broadcast is not in stereo the word
Mono will appear.
For ATV programmes
Stereo… Press
OI/II to select Stereo or Mono.
Bilingual… Bilingual transmissions are rare. If they are
transmitted the word Dual will display. Choose the
required programme number and if the word Dual
appears press OI/II to select Dual 1, Dual 2 or Mono.
For DTV programmes
For stereo or dual mono broadcasts, press OI/II and use
S
or
R
to select settings.
The settings are as follows:
Stereo Press
R
for Stereo ➝ Left ➝ Right
Dual Mono Press
R
for Dual 1 ➝ Dual 2 ➝Dual
Mono
Surround
Stereo and Bilingual Transmissions
gpg