Filter
Top Products
91
Configuring the IPR
In order to access the IPR unit remotely, the IPR Server must be setup to allow remote connections.
1 Disable Remote Enables/Disables acceptance of remote connections by the IPR server.
2 Time Out Value Specifies a value (in seconds) to wait for a signal from the Surveillix Remote Client. If a
signal is not received by that time, the connection is dropped.
3 Center Port Used by the IPR to transfer the connection data.
4 Image Port Used by the IPR to transfer the image data.
5 Search Port Used by the IPR to transfer the search data
Configuring the Server for Remote Connection
1. Enter Setup on the IPR unit.
2. Click the Network Setup Button to open the Network Menu.
3. Uncheck the Disable Remote Control option. You should now be allowed to adjust port settings if necessary.
NOTE: If you are using a Firewall, it may be necessary to adjust the port settings on both the IPR and the Firewall. Contact the
Network Administrator for more information.
4. Click OK.
5. Make sure a User account is created. Without a user account, the Administrator account must be used.
6. The IPR server is now ready to receive incoming connections.
Access Remote Connection
1. Open the Remote Software
2. Click on the icon of the server as defined previously
3. Enter the user name and password of an authorized remote user as defined in Network > Client Setup > User Account on the E-
Series system.
NOTE: User Name and Password are both case sensitive
4. Click the Connect Button