Filter
Top Products
Chapter 8: Using the TV’s features
76
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 27HLV95 *Web 213 : 276
Adjusting the audio (continued)
Using the SRS WOW™ surround sound
feature
WOW
™
is a special combination of SRS Labs audio
technologies (SRS 3D, FOCUS, and TruBass) that creates a
thrilling surround sound experience with deep, rich bass from
stereo sound sources. Your TV’s audio will sound fuller, richer,
and wider.
To adjust the WOW
™
settings:
1. Put the TV in STEREO mode (see “Selecting stereo/SAP
broadcasts” on page 74).
2. Press MENU and open the Audio menu.
3. Highlight Advanced Audio Settings and press ENTER.
Audio Settings
Advanced Audio Settings
Audio Setup
Audio
4. Press zy to highlight the WOW feature you want to
adjust, and then press x • to adjust the item.
Done
Advanced Audio Settings
WOW: SRS 3D
WOW: FOCUS
WOW: TruBass Low
Reset
Off
Off
• WOW: SRS 3D — To turn the surround sound effect On
or Off.
Note: If the broadcast is monaural, the 3D effect does not
work.
• WOW: FOCUS — To turn the vocal emphasis effect On
or Off.
• WOW: TruBass — To select the desired bass expansion
level (High, Low, or Off).
5. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Turning off the built-in speakers
Use this feature to turn off the TV speakers when you connect
an audio system to your TV (see “Connecting a digital audio
system” on page 22).
To turn off the built-in speakers:
1. Press MENU and open the Audio menu.
2. Highlight Audio Setup and press ENTER.
Audio Settings
Advanced Audio Settings
Audio Setup
Audio
3. Press z to highlight the Speakers field, and then press x •
to select Off.
Done
Audio Setup
MTS
Language
Reset
Stereo
Optical Output Format
Dolby Digital/Surround
English
Speakers
On
DVD Audio
Stereo
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
To turn on the built-in speakers:
Select On in step 3 above.
Selecting the optical audio output
format
Use this feature to select the optical audio output format when
you connect a Dolby Digital decoder or other digital audio
system to the Optical Audio Out terminal on the TV (see
“Connecting a digital audio system” on page 22).
To select the optical audio output format:
1. Press MENU and open the Audio menu.
2. Highlight Audio Setup and press ENTER.
Audio Settings
Advanced Audio Settings
Audio Setup
Audio
3. Press z to highlight the Optical Output Format field, and
then press x • to select either Dolby Digital/Surround or
PCM, depending on your device.
Done
Audio Setup
MTS
Language
Reset
Stereo
Optical Output Format
Dolby Digital/Surround
English
Speakers
On
DVD Audio
Stereo
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
#01E_069-076_27HLV95 05.10.6, 11:08 AM76
Black