Filter
Top Products
(E) 51/57H94
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
68
You can label each video input source according to the type of
device you connected to each source, from the following preset
list of labels:
– – (default label)
Hide (to hide an unused input in the Input Selection window)
Audio Receiver
VCR
Video Recorder
Laser Disk
Compact Disc
DVD
DTV
Satellite/DSS
Cable
Note:
• If you set up devices in TheaterNet,™
the associated inputs are
automatically labeled and cannot be relabeled until you remove
the device from TheaterNet (see page 44).
• If you set up a cable box in VIDEO 1, it will automatically be
labeled and cannot be relabeled until you remove the device
from the TV Guide On Screen setup.
•You cannot select IEEE-1394 devices through the INPUT
SELECTION window; however, you can select and control
IEEE-1394 devices through TheaterNet (see page 44).
To label the video input sources:
1. Press MENU and open the PREFERENCES menu.
2. Highlight INPUT LABELING and press ENTER.
Preferences
Favorite Channels
Closed Caption Mode
Closed Caption Advanced
Input Labeling
Menu Language
Navigate Select Back Exit
DVD RTN
CH RTN
EXIT
Off
English
3. Press z or y to highlight the video source you want to
label.
4. Press x or • to select the desired label for that input source.
If a particular input is not used, you can select “HIDDEN”
as the label, which will cause
that input to be “grayed
out” in the input list and
skipped over when you press
the INPUT button on the
remote control.
5. To save the labels, highlight
SAVE and press ENTER.
Chapter 8: Using the TV’s features
Input labeling example:
If you connect a VCR to VIDEO 1, a DVD player to
ColorStream HD-1, and a high definition satellite receiver to
HDMI, and then label the video input sources accordingly (as
shown in step 4 at left), when you press INPUT or TV/VIDEO,
the INPUT SELECTION screen would look like the screen
below right:
Input Selection screen Input Selection screen with
with no inputs labeled inputs 1, 4, and 6 labeled,
and input 5 hidden.
To clear the input labels:
1. Press MENU and open the PREFERENCES menu.
2. Highlight INPUT LABELING and press ENTER.
3. Highlight RESET and press ENTER.
4. Highlight SAVE and press ENTER.
Preferences
Favorite Channels
Closed Caption Mode
Closed Caption Advanced
Input Labeling
Menu Language
Navigate Select Back Exit
DVD RTN
CH RTN
EXIT
Off
English
Save Cancel
Video 1Video 1
Video 3
Video 2
Input Labeling
--
--
VCR
Color Stream HD 1
HDMI
Color Stream HD 2
ANT 2
--
--
--
--
Reset
Note: Labels for devices you set up in TheaterNet will not be
cleared until you remove the device from TheaterNet (see
page 44). The screen above right illustrates an example of the
Input Labeling screen after it was reset that still shows the
VCR label for VIDEO 1 because the VCR was set up in
TheaterNet.
Labeling the video input sources
Save Cancel
Video 1Video 1
Video 3
Video 2
Input Labeling
--
--
VCR
Color Stream HD 1
HDMI
Color Stream HD 2
ANT 2
--
--
--
--
Reset
H94(E)067-76(8a-UseTV) 11/3/04, 11:17 AM68