Filter
Top Products
(E) 52/62HMX94
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
42
Chapter 6: Setting up your TV
Manually adding and deleting channels
in the channel memory
After you have programmed the channels automatically, you can
manually add or delete individual channels in the channel
memory.
To add or delete channels in the channel memory:
1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3).
3. Open the TERRESTRIAL menu, highlight CHANNEL
ADD/DELETE, and then press ENTER.
Note: If you have a cable box connected to ANT 1 during
TV Guide On Screen setup, the TERRESTRIAL menu will not
be accessible and you must then use the TV Guide
On Screen channel editor to add/delete channels.
Te rrestrial
Input Configuration
Channel program
Channel Add
/
Delete
Navigate Select Back Exit
DVD RTN
CH RTN
EXIT
Signal Meter
4. The illustration below shows channels programmed for the
ANT 1 antenna input. To view the list of channels
programmed for the ANT 2 antenna input, highlight
CHANGE ANTENNA and press ENTER.
2Analog 1
3Analog 1
4Analog 1
5Analog 1
6Analog 1
7Analog 1
8Analog 1
Channel Signal Antenna
Channel Add/Delete
Change Antenna
Clear All
Save
Cancel
Programming channels into the TV’s channel memory (continued)
To add a channel to the channel memory:
Highlight the unchecked box next to the channel number
you want to add, and then press ENTER to check the box.
To manually add digital subchannels on a physical channel:
Use the Channel Numbers and the Dash (–/100) on the
remote control to enter the channel number (for example,
56–1).
If the channel is found, the number will be added to the list
and the box will be checked.
If the channel is not found, a message will appear.
To remove a channel from the channel memory:
Highlight the checked box next to the channel number you
want to remove, and then press ENTER to uncheck the
box.
To save your new settings:
Highlight SAVE and press ENTER.
To revert to your original settings:
Highlight CANCEL and press ENTER before saving.
To remove all channels from the channel memory:
Highlight CLEAR ALL and press ENTER, and then
highlight SAVE and press ENTER.
Note:
•This action applies to the current antenna input only.
To delete/add channels on the other input, highlight
CHANGE ANTENNA and press ENTER.
•This action cannot be cancelled unless you highlight
CANCEL and press ENTER before saving your changes.
2 Analog 1
3 Analog 1
4 Analog 1
5 Analog 1
6 Analog 1
7 Analog 1
8 Analog 1
Channel Signal Antenna
Channel Add/Delete
Change Antenna
Clear All
Save
Cancel
HMX94(E)040-43(6a-Setup) 9/28/04, 10:53 AM42