Filter
Top Products
(E) 46/52/62HM94
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
9
Reset button
0
MENUVOLUMECHANNELEXITTV/VIDEO POWER
TV front touchpad and side panel controls and connections
Connecting your TV
2
MENUVOLUMECHANNELEXITTV/VIDEO POWER
MENU
5
TV/VIDEO
2
EXIT
3
zyx •
4
Channel
zy
7
Volume
x •
8
Green/Red LEDs
9
Front touchpad*
1
Remote sensor
(behind the screen)
— Point the remote
control toward this area of the TV screen. See “Remote
control effective range” on page 26.
2
TV/VIDEO
— Repeatedly press to change the source you are
viewing
(ANT 1, ANT 2, VIDEO 1, VIDEO 2, VIDEO 3,
HDMI 1, HDMI 2, ColorStream HD1, ColorStream HD2)
.
3
EXIT
— Press to close an on-screen menu instantly.
4
ARROWS
zyx • — When a menu is on-screen, these
buttons function as down/up/left/right menu navigation
buttons.
5
MENU
— Press to access the menu system (see page 34).
When a menu is on-screen or the TV Guide On Screen
program guide is open, this button functions as the ENTER
button.
6
POWER
— Press to turn the TV on and off.
7
CHANNEL
yz — When no menu is on-screen, these
buttons change the channel (programmed channels only; see
page 41). When a menu is on-screen, these buttons function
as up/down menu navigation buttons.
8
VOLUME
x • — When no menu is on-screen, these
buttons adjust the volume level. When a menu is on-screen,
these buttons function as left/right menu navigation
buttons.
9
Green and Red LEDs
— When green lights solid (not
blinking), it indicates that the TV power cord is plugged in
and the power is OFF. This is called standby mode.
Note: When you first plug in the power cord, the green LED
will blink 3 times. After approximately 30 seconds, the green
LED will light continuously, at which point you can press
POWER to turn ON the TV.
When red lights solid (not blinking), it indicates that the
TV power cord is plugged in and the POWER is ON.
See “LED indications” on page 94 for additional
information.
0
RESET
— If the TV stops responding to the controls on
the remote control or TV front panel and you cannot turn
the TV off or on, press this button to reset the TV.
Note: The RESET button is recessed, so you will need to use
the end of a paper clip or similar object to press the button.
!¡
VIDEO-3
— The side panel A/V connections are referred to
as “VIDEO 3” and include standard A/V connections plus
optional S-video. (The VIDEO 1 and VIDEO 2 A/V
connections are on the TV’s back panel; see page 10.)
!™
Memory card slots
— Insert a memory card into one of
the memory card slots to view JPEG files (such as photos)
as a “slide show” on your TV or listen to MP3 audio files
(see page 82).
Remote sensor
1
POWER
6
Front of TV
{
{
Memory card
slots
!™
*Gently touch the printed keys on the touchpad.
Side panel
Right side of TV
VIDEO-3 IN
!¡
HMX94(E)009-11(2A-Cnct) 9/28/04, 10:21 AM9