Toshiba 62HM95 Projection Television User Manual


 
80
Chapter 8: Using the TV’s features
(E) 46/52/62HM95
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Using CableClear
/DNR (digital noise
reduction)
The CableClear
/DNR digital noise reduction feature allows
you to reduce visible interference in your TV picture. This may
be useful when receiving a broadcast with a weak signal
(especially a Cable channel) or playing a noisy video cassette
or disc. This feature is enabled for 480i signals only.
NOTE: The CableClear™/DNR feature does not function in
ColorStream, HDMI (DVI), ATSC, IEEE1394, and digital Cable
modes.
To select CableClear/DNR preferences:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
3. Press z to highlight the CableClear/DNR field, and then
press x or to make a selection.
Picture Settings
Advanced Picture Settings
Theater Settings
Video
Done
Cool
Lamp Mode Low Power
Reset
Color Temperature Cool
Dynamic Contrast On
ANT 1Advanced Picture Settings
MPEG Noise Reduction Low
CableClear Auto
Note:
If the current input is Antenna, Video 1, Video 2, or Video 3,
the menu will display the text “CableClear.” The available
selections are Off, Low, Middle, High, and Auto.
If the current input is ColorStream HD1, ColorStream HD2, or
HDMI, and the video resolution is 480i, the menu will display
the text “DNR.” The available selections are Off, Low, Middle,
High, and Auto. Auto will react proportionally to the strength
of the noise. Low, Middle, and High will reduce the noise in
varying degrees from lowest to highest, respectively.
If the current input is ColorStream HD1, ColorStream HD2, or
HDMI, and the video resolution is not 480i, the menu will
display the text “DNR” and will be “grayed out” with “Off”
selected.
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Adjusting the picture (continued)
Selecting the color temperature
You can change the quality of the picture by selecting from three
preset color temperatures (cool, medium, and warm), as
described below.
To select the color temperature:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
3. Press z to highlight the Color Temperature field, and then
press x or to select the mode you prefer (Cool, Medium,
or Warm).
Advanced Picture Settings
Picture Settings
Theater Settings
Video
Advanced Picture Settings
Done
Cool
Lamp Mode Low Power
Reset
Color Temperature Cool
Dynamic Contrast On
ANT 1Advanced Picture Settings
MPEG Noise Reduction Low
CableClear Auto
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Note: If you select one of the factory-set picture modes (Sports,
Standard, or Movie) and then change the color temperature, the
picture mode automatically changes to Preference in the Picture
Settings menu.
Mode Picture Quality
cool blueish
medium neutral
warm reddish
HM95_R2_079-86_061505 6/27/05, 5:11 PM80