Toshiba 62HM95 Projection Television User Manual


 
86
Chapter 8: Using the TV’s features
(E) 46/52/62HM95
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Adjusting the audio (continued)
Using the SRS WOW
surround sound
feature
WOW
is a special combination of SRS Labs audio
technologies (SRS 3D, FOCUS, and TruBass) that creates a
thrilling surround sound experience with deep, rich bass from
stereo sound sources. Your TVs audio will sound fuller, richer,
and wider.
To adjust the WOW
settings:
1. Put the TV in STEREO mode (see Selecting stereo/SAP
broadcasts on page 84).
2. Press MENU and open the Audio menu.
3. Highlight Advanced Audio Settings and press ENTER.
Audio Settings
Advanced Audio Settings
Audio Setup
Audio
4. Press z or y to highlight the WOW feature you want to
adjust, and then press x or to adjust the item.
Done
Advanced Audio Settings
WOW: SRS 3D
WOW: FOCUS
WOW: TruBass Low
Reset
Off
Off
WOW: SRS 3D To turn the surround sound effect On
or Off.
Note: If the broadcast is monaural, the 3D effect does not
work.
WOW: Focus To turn the vocal emphasis effect On or
Off.
WOW: TruBass To select the desired bass expansion
level (High, Low, or Off ).
5. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Turning off the built-in speakers
Use this feature to turn off the TV speakers when you connect
an audio system to your TV (see Connecting a digital audio
system and Connecting an analog audio system on page 20).
To turn off the built-in speakers:
1. Press MENU and open the Audio menu.
2. Highlight Audio Setup and press ENTER.
Audio Settings
Advanced Audio Settings
Audio Setup
Audio
3. Press z to highlight the Speakers field, and then press x or
to select Off.
Done
Audio Setup
MTS
Language
Speakers On
Optical Output Format Dolby Digital
Reset
Stereo
English
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
To turn on the built-in speakers:
Select On in step 3 above.
Selecting the optical audio output
format
Use this feature to select the optical audio output format when
you connect a Dolby Digital decoder or other digital audio
system to the Optical Audio Out terminal on the TV (see
Connecting a digital audio system on page 20).
To select the optical audio output format:
1. Press MENU and open the Audio menu.
2. Highlight Audio Setup and press ENTER.
Audio Settings
Advanced Audio Settings
Audio Setup
Audio
3. Press z to highlight the Optical Output Format field, and
then press x or to select either Dolby Digital or PCM,
depending on your device.
Done
Audio Setup
MTS
Language
Speakers On
Optical Output Format
Dolby Digital
Reset
Stereo
English
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
______________
• WOW, SRS and
symbol are trademarks of SRS Labs, Inc. WOW technology is
incorporated under license from SRS Labs, Inc.
HM95_R2_079-86_061505 6/27/05, 5:12 PM86