Filter
Top Products
Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
12
Connecting an A/V receiver
This connection allows you to use an A/V (audio/video) receiver to
enhance your TV’s sound.
If you have a system with Dolby Pro Logic
®
surround sound, you can
add to the realism of the sound by using the TV speakers as center
channel speakers.
You will need:
• one set of standard A/V cables
• one single audio cable for the Audio Center Channel
ANT
(
75
)
ANT-1 OUT ANT- 2
ON OFF
CHANNEL IN
AUDIO CENTER
OUT
RL
VAR
AUDIO
OUT
VIDEO
L/
MONO
AUDIO
R
IN
DVD IN
C
R
C
B
Y
L/
MONO
AUDIO
S-VIDEO
VIDEO
R
VIDEO 1 VIDEO 2
COLOR
STREAM
AUDIO
R
L
ON OFF
Dolby Pro Logic* surround sound system
connection example
T V
Right
speaker
Left
speaker
Surround
speaker L
Surround
speaker R
VCR
A/V receiver
Audio Video
Video
Audio
Video
Audio
center
channel
Audio
LDP/DVD
To A/V receiver
Center
out
TV
in
Video
out
From Antenna
TV
Note:
Refer to the instructions provided with your
A/V receiver for details about your surround
sound system.
When the Audio Center Channel ON/OFF
switch is in the ON position, the TV speakers
will function only as center channel speakers.
To adjust the volume of the center channel
speakers, use the center level control on
the A/V receiver.
To use the TV speakers as normal speakers,
set the Audio Center Channel ON/OFF switch
to the OFF position.
*
Dolby Pro Logic is a registered trademark of Dolby Laboratories Licensing Corporation.
Caution:
To avoid damaging the speakers:
• Turn off the TV before connecting or
disconnecting the Audio Center Channel
cable.
• Do not connect from the A/V receiver’s
Center Speaker OUT terminal (amplified
signal) to the TV’s Audio Center Channel
IN terminal.