Filter
Top Products
24
Setting the color temperature
Use this procedure to set color tone produced by the plasma
display.
Example: Setting “1” (See chart at right)
Press the PROCEED button on the remote controller to
display the MAIN MENU on the screen, then...
1. Use the ▲ and ▼ buttons to select “PICTURE,” then
press the PROCEED button.
The “PICTURE” screen appears.
2. Use the ▲ and ▼ buttons to select “COLOR TEMP.”
PICTURE
: MEMORY
: 2
: OFF
RG
SEL. ADJ. RETURN
EXIT
CONTRAST
BRIGHTNESS
SHARPNESS
COLOR
TINT
PICTURE MODE
COLOR TEMP.
NR
3. Use the
ᮤ
and
ᮣ
buttons to select “1.”
The mode switches as follows when the
ᮤ
and
ᮣ
buttons are pressed:
→ 2 ↔ 3 ↔ PRO ↔ 1 ←
• See page 25 to set “PRO.”
COLOR TEMP.
1
:
• If neither the
ᮤ
or
ᮣ
button is pressed within 5 seconds,
the current selection is set and the previous screen reappears.
4. Once the setting is completed...
Press the EXIT button to return to the main menu.
To close the main menu, press the EXIT button once
more.
Information
Ⅵ Setting the color temperature
1 ......................High (bluer)
2......................... Middle (Standard)
3 ......................Low (redder)
Ⅵ Restoring the factory default settings
Select “RESET” under the function menu. Note that this
also restores other settings to the factory defaults.