Filter
Top Products
5
You can attach your optional mounts or stand to the plasma
display in one of the following two ways:
• While it is upright. (See Drawing A)
• As it is laid down with the screen face down (See Drawing
B). Lay the protective sheet, which was wrapped around
the display when it was packaged, beneath the screen
surface so as not to scratch the screen face.
• This device cannot be installed on its own.
Be sure to use a stand or original mounting
unit. (Wall hanging bracket, Pedestal, etc.)
See page 6.
• For correct installation and mounting it is
strongly recommended to use a trained,
authorized TOSHIBA dealer.
Failure to follow correct mounting
procedures could result in damage to the
equipment or injury to the installer.
Product warranty does not cover damage
caused by improper installation.
Ventilation Requirements for
enclosure mounting
To allow heat to disperse, leave space between
surrounding objects as shown on the diagram
at right when installing.
How to Attach Options to the Plasma Display
Drawing A
Drawing B
1.22" (31mm)
43.7" (1110mm)
29.5" (748mm)
2" (50mm)
Wall
Wall
2" (50mm)
1.22" (31mm)
2" (50mm)
• Use only Listed Cart or Stand, or mounting
kit or stand provided by manufacturer.