Filter
Top Products
6. Carefully slide the Management Module back into the
Multichannel Media Converter.
Ensure that the frame of the Management Module runs smoothly
between the guides at the bottom of the Multichannel Media
Converter. Note a slight resistance just before the Management
Module frame comes flush with the rear panel of the Multichannel
Media Converter. At this point, ensure that the edges of the
Management Module run parallel to the corresponding edges of
the Multichannel Media Converter. Then, apply gentle pressure to
seat the Management Module in the Multichannel Media
Converter.
7. Secure the Management Module to the Multichannel Media
Converter by tightening the two (2) thumbscrews.
2.3.2 Installing Power Supply Module
1. Locate the protective plate installed over the redundant Power
Supply Module installation slot at the rear of the Multichannel
Media Converter.
2. Remove the protective plate from the Multichannel Media
Converter by unscrewing two (2) thumbscrews that secure the
protective plate to the Multichannel Media Converter redundant
Power Supply Module installation slot.
3. Carefully slide the Power Supply Module into the Multichannel
Media Converter installation slot.
Ensure that the frame of the Power Supply Module runs smoothly
between the guides at the bottom of the Multichannel Media
Converter. Note a slight resistance just before the Power Supply
Module frame comes flush with the rear panel of the Multichannel
Media Converter. At this point, ensure that the edges of the
Management Module run parallel to the corresponding edges of
the Multichannel Media Converter. Then, apply gentle pressure to
seat the Power Supply Module in the Multichannel Media
Converter.
4. Secure the Power Supply Module to the Multichannel Media
Converter by tightening the two (2) thumbscrews.
2 INSTALLATION
2.5
MULTICHANNEL MEDIA CONVERTER