Filter
Top Products
(M)odify any of this or (C)ontinue? [M] m
For each of the following questions, you can press
<Return> to select the value shown in braces, or you
can enter a new value.
NETWORK PARAMETERS:
-------------------
Do you want a LAN interface? [Y]
This board's LAN IP address(0.0.0.0 = RARP)?
[192.168.1.99]
Use a subnet mask for the LAN interface? [N] y
Subnet mask for LAN (0 for none)? [0.0.0.0]
Should there be a default gateway for packet routing?
[N] y
What is its IP address? [0.0.0.0]
CONSOLE PARAMETERS:
-------------------
Baud rate for serial channels [9600]
ETHERNET PARAMETERS:
--------------------
Do you want to change the board's Ethernet address?
[N] y
Byte 0 must be 00
What should byte 1 be? [A0]
What should byte 2 be? [D2]
What should byte 3 be? [2F]
What should byte 4 be? [80]
What should byte 5 be? [82]
SNMP PARAMETERS:
----------------
Get community [public]
Set community [private]
Trap destination [192.168.1.15]
Trap community [trap]
System name [LAN]
System location [location]
System Contact [administrator]
How long (in seconds) should CPU delay before
starting up? [5]
NOTE: Changing the CPU delay value above from 5 to 15 makes it easier
to continue again later.
When configuration is complete, the startup screen comes up with the
new parameters.
To continue modifying the configuration parameters, again type ‘m’ to
modify.
7. Type ‘c’ to save the configuration, initialize the system, and
continue:
Updating parameter storage. This may take a
while...Done
Initialization...
8. Observe the illuminated Ready Multichannel Media Converter
Management LED.
NOTE: The Multichannel Media Converter can be managed at the
terminal emulation interface. See Section 3 OPERATION.
2 INSTALLATION
2.13
MULTICHANNEL MEDIA CONVERTER