Filter
Top Products
3 OPERATION
3.3
MULTICHANNEL MEDIA CONVERTER
3.2 Using a Terminal Emulator
The Multichannel Media Converter Management Module terminal
emulator interface permits the network administrator to display status
messages and to display and to modify selected network settings.
CAUTION: IP parameters can be set and/or modified ONLY at the
attached terminal Interface.
The Multichannel Media Converter command-line interface is accessible
using a terminal or terminal emulator attached to the PS/2 serial port on
the Multichannel Media Converter.
NOTE: The serial port cable is attached directly to a DTE device through
the serial port management control cable shipped with the Multichannel
Media Converter.
1. Locate a PC equipped with any terminal emulation program.
2. Connect the Multichannel Media Converter to the PC by
connecting the miniDIN end of the control cable (
provided) to the
Multichannel Media Converter Management PS/2 port and the
other end of the cable to the PC DB-9 serial port connector.
NOTE: By default, the Multichannel Media Converter uses the
following serial port parameter values:
bits per second 9600
stop bits 1
data bits 8
parity NONE
flow control Xon/Xoff
3. Using methods appropriate to the attached terminal, verify that
the serial port parameters of the attached terminal match the
Multichannel Media Converter port parameter values. If
necessary, modify the attached terminal port parameter values.
4. Start the terminal emulation program.
5. Cycle power to the Multichannel Media Converter by
disconnecting the power cord from the external AC outlet and
then reconnecting the power cord to the external AC outlet...
After system initialization, a banner display comes up.
****************************************************
* Software version: v2.0.4T *
* Version date: 25/02/01 *
* Vendor: Transitiob Betworks *
* Model: MFETF1013-120 *
****************************************************