Filter
Top Products
2.5 Powering the Multichannel Media Converter
NOTE: The Multichannel Media Converter does NOT have a power
ON/OFF switch. Power is applied to, and removed from, the Multichannel
Media Converter by connecting and disconnecting the power cord.
NOTE: The Main Power Supply Module and the Redundant (backup)
Power Supply Module each has a separate power cord. Increase
protection to the Multichannel Media Converter from operational failure
due to power circuit failure by connecting the two power cords to outlets
on separate power circuits.
To power the Multichannel Media Converter through the AC Power
Supply Module(s):
1. Locate Power Supply Module(s) at back of Multichannel Media
Converter.
2. Connect female end of power cord to power receptacle on Power
Supply Module.
3. Plug male end of power cord into correct voltage AC rack or wall
outlet.
4. If optional Redundant (backup) Power Supply Module is installed
in Multichannel Media Converter, repeat steps 2 and 3 for second
Power Supply Module.
4. Verify that Multichannel Media Converter is powered by
observing illuminated LED(s) and noting operation of Power
Supply Module fan(s).
2.8
METTF10xx, MFETF10xx