Filter
Top Products
Operation
38 Vidikron VL-52 and VL-57 Installation/Operation Manual
PRE
L
IMINAR
Y
Film Mode: To smooth out moving images from interlaced, standard-definition (SD) sources,
select
Film Mode and set it to Automatic.
In most cases, the DView detects the proper “pull-down” rate and vertical frequency.
However, if your source is jittery and/or tearing you may wish to specify the pull-down rate
(2:2 or 3:2) to ensure stable processing for that source.
Auto Backlight: Select Auto Backlight from the Setup menu and set it to On to have the
DView adjust the Backlight setting automatically, according to the ambient light level in the
viewing area.
OSD Timer: Use the or button to set the OSD Timer. This timer controls how long the
menus remain on-screen after selecting them. Select from 0 to 60 seconds, in 10-second
increments. When you set the OSD to 0, the menus remain on-screen until you hide them by
pressing EXIT.
Auto Off: Set Auto Off to 30, 60 or 120 minutes to have the DView go into standby mode
when no source signal is present for the selected amount of time.
When Auto Off is set to zero (0) minutes (disabled), the DView remains in normal operating
mode, regardless of the presence or absence of an input sync signal.
HDMI CSC (Color Space Control): If the color space of the incoming signal on the HDMI1 or
HDMI2 input is known, select
HDMI CSC from the Setup menu and set it to RGB or
Component.
In most situations, the Auto setting works well.
ISF Calibration Use the ISF Calibration menu to perform advanced picture quality adjustments. This menu
should be used by ISF-certified technicians only.
Picture Adjust: The controls in this menu are identical to those in the main Picture Adjust
menu, but are accessible only by entering the ISF Calibration menu passcode. This makes it
possible to restore the picture quality settings to what they were when the DView was
installed, simply by recalling the “ISF Night” or “ISF Day” preset.
•Brightness: Refer to Brightness on page 29.
•Contrast: Refer to Contrast on page 30.
• Color: Refer to Color Saturation on page 31.
•Tint: Refer to Tint on page 31.
•Sharpness: Refer to Sharpness on page 32.
• ADC Phase Adj.: This control works similarly to the Phase adjustment for RGB signals
(refer to
Phase on page 34). Use it to improve the apparent sharpness of 720p and
lower-resolution Component, S-Video or Composite sources. For best results, adjust ADC
Phase while displaying a “Sharpness” pattern (
Figure 4-5).
• DNR: Refer to DNR on page 32.
• MPEG NR: Refer to MPEG NR on page 32.
• Backlight: Refer to Backlight on page 32.
ISF Calibration
Picture Adjust
White Balance
Blue Enable
Baud Rate
Factory Reset
Splash Duration
➤
You must enter a passcode to access the ISF Calibration menu.
Note