Filter
Top Products
ENG
ADVANCED OPERATION
29
2-3-1 Projector Settings
Projector Setting selections
Use ▲ and ▼ to navigate Selections of Projector Settings Sub-Menu (Fig. 2-3-1)
Press to confirm the Sub-Menu selection.
Press to go to previous menu.
AUTO SOURCE
ON
FIXED SYNC
OFF
AUTO
SHUTDOWN
OFF
LAMP MODE
NORMAL
DAYLIGHT
SENSOR
AUTO
PROJECTION
FRONT/DESK
Fig. 2-3-1
Projector Settings Sub-Menu
AUTO SOURCE
OFF ON
Automatically select the next active input source
Select ON to enable the feature; OFF to disable the feature
OFF ON
FIXED SYNC
Use default timing data stored in the projector instead of
consistent auto sync sampling. Auto sync will cause incorrect
image sizing If the on-screen image has black border. The
problem is further complicated if the source content’s screen
resolution is not consistent.
Select ON to enable the feature; OFF to disable the feature
AUTO
SHUTDOWN
5 15 30 45 60 OFF
Automatically shut down the projector after standby 5 / 15 /
30 / 45 / 60 minutes or feature off.
LAMP MODE
NORMAL
ECO
Select lamp power efficiency mode
Normal: Standard mode, maximum lumen and power output
Eco: Reduced power, less fan noise, and lamp life can be
extended.
DAYLIGHT
SENSOR
AUTO MANUALOFF
Adjust the viewing condition based on ambient light environment
OFF: Disable the feature
Auto: Enable the feature and adjust automatically
Manual: Enable the feature and adjust manually
MANUAL
MIDDLE HIGHLOW
Manually choose the light rate.
Low: Dim environment
Middle: Average light environment
High: Bright environment
PROJECTION
FRONT / DESK REAR / DESK
FRONT / CEILING REAR / CEILING
Projection method selections
Use ▲ and ▼ to choose the right projection method.