Filter
Top Products
CONFIDENTIAL – DO NOT COPY
Page 7-51
File No. SG-0198
Read
The Read command is used to initiate a burst read access to an active (open) row. The value on the
BA0, BA1 inputs selects the bank, and the address provided on inputs A0-Ai, Aj (where [i = 9, j =
don’t care] for x8; where [i = 9, j = 11] for x4) selects the starting column location. The value on input
A10 determines whether or not Auto Precharge is used. If Auto Precharge is selected, the row being
accessed is precharged at the end of the Read burst; if Auto Precharge is not selected, the row
remains open for subsequent accesses.
Write
The Write command is used to initiate a burst write access to an active (open) row. The value on the
BA0, BA1 inputs selects the bank, and the address provided on inputs A0-Ai, Aj (where [i = 9, j =
don’t care] for x8; where [i = 9, j = 11] for x4) selects the starting column location. The value on input
A10 determines whether or not Auto Precharge is used. If Auto Precharge is selected, the row being
accessed is precharged at the end of the
Write burst; if Auto Precharge is not selected, the row
remains open for subsequent accesses. Input data appearing on the DQs is written to the memory
array subject to the DM input logic level appearing coincident with the data. If a given DM signal is
registered low, the corresponding data is written to memory; if the DM signal is registered high, the
corresponding data inputs are ignored, and a Write is not executed to that byte/column location.
Auto Refresh
Auto Refresh is used during normal operation of the DDR SDRAM and is analogous to CAS Before
RAS (CBR) Refresh in previous DRAM types. This command is nonpersistent, so it must be issued
each time a refresh is required.The refresh addressing is generated by the internal refresh controller.
This makes the address bits “Don’t Care” during an Auto Refresh command. The 256Mb DDR
SDRAM requires Auto Refresh cycles at an average periodic interval of 7.8μs (maximum).
Self Refresh
The Self Refresh command can be used to retain data in the DDR SDRAM, even if the rest of the
system is powered down.When in the self refresh mode, the DDR SDRAM retains data without
external clocking. The Self Refresh command is initiated as an Auto Refresh command coincident
with CKE transitioning low. The DLL is automatically disabled upon entering Self Refresh, and is
automatically enabled upon exiting Self Refresh (200 clock cycles must then occur before a Read
command can be issued). Input signals except CKE (low) are “Don’t Care” during Self Refresh
operation.