Filter
Top Products
14
2"
1. On Teleport™ press and hold SETUP until the
last-selected mode key blinks twice.
2. Enter 975 on the numeric keypad.
NOTE: If the LED emits one long, steady blink,
the operation was not successful; repeat the
sequence.
3. Press a mode key once (e.g.,TV, DVD/VCR,
SAT, AMP) to assign a mode for learning.
Programming a Learned Key
NOTE: If more than 15 seconds pass between key
presses, the remote exits programming.
6. On the original remote, press and hold the key you
want Teleport™ to learn. The Teleport™ remote control
LED will blink rapidly, then turn off. Continue holding the
key on the original remote until the Teleport™ remote
control LED blinks twice.
NOTE: If the LED on Teleport™ emits one long, steady
blink, the operation was not successful; repeat the
sequence. If the function is still not captured, press and
hold SETUP to exit programming and review the “Learning
Precautions” on the previous page. If needed, also see
“Troubleshooting” on page 28. After review, start
programming again at Step 1.
4. Press the key on Teleport™ that is to learn the new
code.
5. Place the Teleport™ remote control head-to-head
(about 2 inches apart) from your original remote control.
Locate the key on your original remote control that you
want the Teleport™ remote control to learn.
7. Repeat Steps 2 through 5 for another mode
and/or key. To exit programming, press and hold
SETUP.
Continued next page...