Wayne-Dalton WDHC-20 Universal Remote User Manual


 
28
NOTE: This operation requires Teleport™ to be the
primary controller in your Z-Wave
®
network.
CAUTION: This operation will PERMANENTLY remove an
un-responsive Z-Wave
®
node from your network even if it
is un-responsive for a temporary condition such as the
light bulb is burned out or the module has become
unplugged. Before performing this operation, thoroughly
investigate the cause to confirm it is due to a catastrophic
condition with the Z-Wave
®
node.
If a Z-Wave
®
node fails to respond in the network, the
HOME key LED on Teleport™ will emit a long red blink
when trying to access the failed node.
1. Press and hold SETUP until the red LED blinks twice.
2. Enter 972 on the numeric keypad. The HOME green
LED will blink continuously.
NOTE: If the HOME red LED emits one long, steady blink,
the operation was not successful; repeat the sequence.
REMOVING A FAILED
Z-WAVE
®
NODE FROM
THE NETWORK
The Teleport™ remote control contains a Custom
Programming Reset program which will remove all
custom programming, except your setup codes.
CAUTION: This operation will PERMANENTLY remove all
custom settings for Volume Lock, Learned Keys, Channel
Lock and numeric keypad keys.
1. On Teleport™ press a mode key (TV, DVD/VCR, SAT,
AMP) then press and hold SETUP until the last-selected
mode key blinks twice.
NOTE: This does not work on the HOME key for home
controls.
2. Enter 980 on the numeric keypad. The last-selected
device key blinks twice, pauses and blinks twice again to
confirm that all custom programming is cleared.
CLEARING CUSTOM PROGRAMMING