Filter
Top Products
21
1. On Teleport™ press the HOME key once.
2. Press and release ADD twice. The HOME key red LED
blinks rapidly.
3. Press the program button on the Z-Wave
®
node.
4. The HOME LED blinks green twice to indicate a
successful operation..
NOTE: If the HOME red LED emits one long, steady blink,
the operation was not successful; repeat the sequence.
Be certain Teleport™ is within 3 ft. of the the node.
Adding a Node to your
Z-Wave
®
Network
To add a Z-Wave
®
node to your Z-Wave
®
network(or start
creating a network,) perform the following steps:
Deleting a Node from a
Z-Wave
®
Network
To remove a Z-Wave
®
node from a Z-Wave
®
network,
perform the following steps:
1. On Teleport™ press HOME once.
2. Press and release DEL twice. The HOME red LED blinks
rapidly.
3. Press the program button on the node.
4. The HOME LED blinks green twice to indicate a
successful operation.
NOTE: If the HOME red LED emits one long, steady blink,
the operation was not successful; repeat the sequence.
If you do have an existing Z-Wave
®
network:
1. Using your existing network’s primary controller, transfer the
network information to Teleport™. (page 26)
Your Teleport™ is now a secondary controller in your Z-Wave
®
network.
NOTE: As a secondary controller, some Z-Wave
®
commands will
not be available such as the ability to add nodes to the network or
create additional secondary controllers.
2. Add the nodes to be controlled to a Teleport™ scene. (page 22)
3. Test your scene by activating the scene. (page 23)
If your scene is not correct, repeat step 2.
4. Repeat steps 2 and 3 for each additional scene you wish to
create.